Natty`s ?

[ranch4x4]

I`m using the PVA applicator that came with Natty`s and I`m wondering just how long I should wait before I start to buff it off?

Should I apply it so that you can barely see it (like P21S) or am I not using enough product?

[awd330]

Originally posted by ranch4x4
I`m using the PVA applicator that came with Natty`s and I`m wondering just how long I should wait before I start to buff it off?

Should I apply it so that you can barely see it (like P21S) or am I not using enough product?

Apply like P21S, but wait a few minutes longer to buff off. I apply to about 2-3 panels then wipe off.

[Poorboy]

Natty recommended doing the entire vehicle and then wiping off:dunno

[ranch4x4]

I think I end up buffing off too quickly, because after buffing I notice left over clear residue. So I think I`m not letting it haze long enough, but it`s in the sunlight when I do it...

It`s hard to get rid of it all even using a little S&W and a MF. :dunno

[Poorboy]

definitely let it sit longer..it`s not s100 or p21s..there`s no rush...

[awd330]

Originally posted by ranch4x4
I think I end up buffing off too quickly, because after buffing I notice left over clear residue. So I think I`m not letting it haze long enough, but it`s in the sunlight when I do it...

It`s hard to get rid of it all even using a little S&W and a MF. :dunno

You may have also used too much product. Just a 2-3 swipes across the wax with the PVA should be enough to do a door panel.

It should only be slightly more difficult to wipe off than P21S.

[ranch4x4]

Originally posted by awd330
You may have also used too much product. Just a 2-3 swipes across the wax with the PVA should be enough to do a door panel.

It should only be slightly more difficult to wipe off than P21S.

Really?

It may have been a combination of using too much product and not letting haze long enough. I couldn`t see any wax when I applied it to my paint so I was doing like 3 swipes for every foot lol.

Is it so clear that it`s hard to see? I feel awkward just dragging the applicator across the surface and not seeing any or hardly any wax.

I`m redoing a couple panels including my hood tomorrow so I`ll try the tips.

Thanks