I have finally ordered some foam pads (two white-polish, one yellow-cut) for my new PC. I have some pre-cleaner and UPP, and a clay bar. I sam till unclear/undecided about the polish. I have light pewter paint in very good condition with some swirls. I`ve read about all the different polishes and SMRs that folks on the board here use and ended up ordering some Hi-Temp light cut (#62?) for a one step polish. I don`t know whether to use just a polish or an SMR or both or even which brand/s. I`m not too keen on the fillers is some of the products. Seems like it would interfere with the UPP, but I don`t know. Since this is my first use of a PC and an involved detail, I want to keep my steps to a fair minimum (as I don`t fully understand the combination of products and pads and layering of this and that). So, here is my detail:
1. Wash and clay bar
2. polish with HT light cut
3. UPP pre cleaner
4. UPP
wheel, tires, etc.
I`d like to have recommendations on the plan, but the polishing/SMR in particular. Some of you guys love the 100 step process and some don`t. Right now, I don`t want to get myself that wound up (and screw it up!).
Bookmarks